Layer 2 Protocol Tunneling Settings - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack
Port List Specify the ports that will enable or disable the filter DHCP server. Tick the All Ports check box to
select all ports.
Action Select Add or Delete to add or delete a filter DHCP server entry.
Server IP The IP address of the DHCP server that specifies an allotted server IP address to the client.
Address
Client MAC Specify the MAC address of the client which allowed the requested IP address from the DHCP
Address server.
Port List Enter the list of ports to use the given filter DHCP server entry. Tick the All Ports check box to
select all ports.
Click Apply to implement the changes.

Layer 2 Protocol Tunneling Settings

The Layer 2 Protocol Tunneling (L2PT) supports traffic of multiple customers across service provider networks. L2PT enables the
BPDU's of the same customer's network to be multicast over specific VLANs in the service provider's network, which in turn
will ensure the same geographically dispersed customer network can implement consistent spanning tree calculations across the
service provider network.
To view this window, click Administration > Layer 2 Protocol Tunneling Settings, as shown below.
The following fields can be configured:
Parameter
Layer 2 Protocol
Tunneling State
Unit
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Filter DHCP Server Port Settings
Figure 2 - 97 Layer 2 Protocol Tunneling Settings window
Description
Use the drop-down menu to choose Enabled or Disabled.
Select the unit to configure.
84