Vlan Translation Settings; Layer 2 Protocol Tunneling Settings - D-Link DGS-3000 Series Reference Manual

Outer TPID
Add Inner Tag
Click the Apply button to accept the changes made for each individual section.

VLAN Translation Settings

This window is used to add translation relationship between C-VLAN and SP-VLAN. On ingress at UNI port, the C-
VLAN tagged packets will be translated to SP-VLAN tagged packets by adding or replacing according the configured
rule. On egress at this port, the SP-VLAN tag will be recovered to C-VLAN tag or be striped. The priority will be the
priority in the SP-VLAN tag if the inner priority flag is disabled for the receipt port.
To view the following window, click L2 Features > QinQ > VLAN Translation Settings as shown below:
The fields that can be configured are described below:
Parameter
From Port / To Port
CVID (1, 5-7)
Action
SVID (1-4094)
Priority
Click the Apply button to accept the changes made for each individual section.
Click the Delete All button to remove all the entries listed.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove a specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

Layer 2 Protocol Tunneling Settings

This window is used to configure Layer 2 protocol tunneling settings.
To view the following window, click L2 Features > Layer 2 Protocol tunneling Settings as shown below:
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Enter an Outer TPID in SP-VLAN tag here.
Specifies that an Inner Tag will be added to the entry. By default, the Disabled check box
is selected.
Figure 4-27 VLAN Translation Settings Window
Description
Use the drop-down menus to select a range of ports to use in the configuration.
Enter the C-VLAN ID to match.
The action indicates to add an S-tag before a C-tag or to replace the original C-tag by an
S-tag.
Enter the SP-VLAN ID.
Use the drop-down menu to select the priority of the s-tag.
92