Basic Lldp Port Settings - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack
Notification Interval
(5-3600)
Click Apply to implement the changes.

Basic LLDP Port Settings

This window is used to display the LLDP port settings on the Switch. The ports can be individually configured to send
notifications to configured SNMP trap receivers.
To view this window, click L2 Features > LLDP > Basic LLDP Port Settings, as shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
port which will delay advertising any successive LLDP advertisements due to change in the
LLDP MIB content. To change the LLDP TX Delay, enter a value in seconds (1 to 8192).
LLDP Notification Interval is used to send notifications to configured SNMP trap receiver(s)
when an LLDP change is detected in an advertisement received on the port from an LLDP
neighbor. To set the LLDP Notification Interval, enter a value in seconds (5 to 3600).
Figure 3 - 62 Basic LLDP Port Settings window
197