Jwac User Account - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack
min)
Idle Time (1-1440
Minutes)
Block Time
(0-300 sec)
Click Apply to implement changes made. To return to the JWAC Port Table Parameter window, click the
Setting Entries link.

JWAC User Account

This window is used to configure JWAC user accounts on the Switch.
To view this window, click Security > Japanese Web-based Access Control (JWAC) > JWAC User Account, as shown
below.
To configure JWAC user settings, click the Add button, which will open the following window:
The following fields can be configured:
Parameter
User Name
VID (1-4094)
New Password
Confirm New
Password
Click Apply to implement changes made.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
1440 minutes. To maintain a constant Port Configuration, tick the Infinite check box.
This parameter specifies the period of time during which there is no traffic for an
authenticated host and the host will be moved back to the unauthenticated state. Enter a
value between 1 and 1440 minutes. A value of Infinite indicates the Idle state of the
authenticated host on the port will never be checked. The default setting is Infinite.
This parameter specifies the period of time a host will keep in a blocked state after it fails to
authenticate. Enter a value between 0 and 300 seconds. The default setting is 60 seconds.
Figure 6 - 85 JWAC User Accounts window
Figure 6 - 86 JWAC User Accounts - Add window
Description
Enter a username of up to 15 alphanumeric characters.
Enter the VLAN ID of the Account you wish to create.
Enter the password of the user. This field is case-sensitive and must be a complete
alphanumeric string.
Retype the password entered in the previous field.
350
Show JWAN All Ports