Lldp Global Settings - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack

LLDP Global Settings

This window is used to configure the LLDP Global Settings on the Switch. When LLDP is enabled the Switch can start to
transmit, receive and process LLDP packets. The specific function of each port will depend on the per port LLDP settings. LLDP
Global State is Disabled by default.
To view this window, click L2 Features > LLDP > LLDP Global Settings, as shown below.
The following parameters can be configured:
Parameter
LLDP Operation State
LLDP Forward
Message State
Message TX Interval
(5-32768)
Message TX Hold
Multiplier (2-10)
ReInit Delay (1-10)
TX Delay (1-8192)
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 3 - 61 LLDP Global Settings window
Description
Used to Enable or Disable LLDP on the Switch.
When LLDP is disabled this function controls the LLDP packet forwarding message based
on individual ports. If LLDP is enabled on a port it will flood the LLDP packet to all ports that
have the same port VLAN and will advertise to other stations attached to the same IEEE
802 LAN.
This interval controls how often active ports retransmit advertisements to their neighbors.
To change the packet transmission interval, enter a value in seconds (5 to 32768).
This function calculates the Time-to-Live for creating and transmitting the LLDP
advertisements to LLDP neighbors by changing the multiplier used by an LLDP Switch.
When the Time-to-Live for an advertisement expires the advertised data is then deleted
from the neighbor Switch's MIB.
The LLDP reinitialization delay interval is the minimum time that an LLDP port will wait
before reinitializing after receiving an LLDP disable command. To change the LLDP Reinit
Delay, enter a value in seconds (1 to 10).
LLDP TX Delay allows the user to change the minimum time delay interval for any LLDP
196