D-Link DGS-3427 - xStack Switch - Stackable Product Manual page 250

x Stack
Click Apply to implement the changes.
To view the settings for a created profile, click its corresponding View button in the Access Profile Table window, revealing the
following window.
The window shown below is the Access Profile Configuration window for Packet Content Mask:
Figure 5 - 9 Access Profile Configuration window (Packet Content Mask)
This window will aid the user in configuring the Switch to mask packet headers beginning with the offset value specified. The
following fields are used to configure the Packet Content Mask:
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
0x0-0xffff) which you wish to filter.
Select UDP to use the UDP port number contained in an incoming packet as the forwarding
criterion. Selecting UDP requires that you specify a source port mask and/or a destination
port mask.
•
src port mask – Specify a UDP port mask for the source port in hex form (hex 0x0-
0xffff).
•
dst port mask – Specify a UDP port mask for the destination port in hex form (hex
0x0-0xffff).
Figure 5 - 8 Access Profile Entry Display (IPv6)
241