D-Link DGS-3427 - xStack Switch - Stackable Product Manual page 247

x Stack
The following parameters can be set, for IP:
Parameter
Profile ID (1-6)
Type
VLAN
Source IP Mask
Destination IP Mask
DSCP
Protocol
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 5 - 5 Access Profile Configuration window (IP)
Description
Type in a unique identifier number for this profile set. This value can be set from 1 to 6.
Select profile based on Ethernet (MAC Address), IP, Packet Content or IPv6 address. This
will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet header.
Select IP to instruct the Switch to examine the IP address in each frame's header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's header.
Select Packet Content to instruct the Switch to examine the packet header.
Selecting this option instructs the Switch to examine the VLAN part of each packet header
and use this as the, or part of the criterion for forwarding.
Enter an IP address mask for the source IP address.
Enter an IP address mask for the destination IP address.
Selecting this option instructs the Switch to examine the DiffServ Code part of each packet
header and use this as the, or part of the criterion for forwarding.
Selecting this option instructs the Switch to examine the protocol type value in each frame's
header. Then the user must specify what protocol(s) to include according to the following
guidelines:
Select ICMP to instruct the Switch to examine the Internet Control Message Protocol (ICMP)
field in each frame's header.
238