Multicast Filtering Mode - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack
Figure 3 - 59 Setup Static Multicast Forwarding Table window
The following parameters can be set:
Parameter
Unit
VID
Multicast MAC
Address
Port Settings
Click Apply to implement the changes made. Click the
Multicast Forwarding Settings window.

Multicast Filtering Mode

This window allows users to configure the Switch to forward or filter the Unregistered Groups per VLAN.
To view this window, click L2 Features > Forwarding & Filtering >Multicast Filtering Mode, as shown below.
The following parameters can be set:
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Description
Select the switch in the switch stack to be modified.
The VLAN ID of the VLAN the corresponding MAC address belongs to.
The MAC address of the static source of multicast packets. This must be a multicast MAC
address.
Allows the selection of ports that will be members of the static multicast group and ports that
are either forbidden from joining dynamically, or that can join the multicast group dynamically,
using GMRP. The options are:
None – No restrictions on the port dynamically joining the multicast group. When None is
chosen, the port will not be a member of the Static Multicast Group.
Egress – The port is a static member of the multicast group.
Figure 3 - 60 Multicast Filtering Mode Settings window
Show All Multicast Forwarding Entries
194
link to return to the Static