System Log Source Interface Settings; System Severity Settings - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack

System Log Source Interface Settings

This window may be used to choose a method for which to save the switch log to the flash memory on the Switch.
To view this window, click Administration > System Log > System Log Source Interface Settings, as shown below.
The following parameters can be configured:
Parameter Description
Interface Name Enter the name of the interface.
IPv4 Address Tick the check box and enter the IPv4 address.
Click Apply to add the entry to the Syslog Source Interface Table. Click

System Severity Settings

The Switch can be configured to allow alerts be logged or sent as a trap to an SNMP agent or both. The level at which the alert
triggers either a log entry or a trap message can be set as well. Use this window to set the criteria for alerts. The current settings
are displayed below the System Severity Table.
To view this window, click Administration > System Severity Settings, as shown below.
Use the drop-down menus to configure the parameters described below.
Parameter
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 33 System Log Save Mode Settings window
Figure 2 - 34 System Severity Settings window
Description
to remove the corresponding entry.
39