Dhcp Server Exclude Address Settings; Dhcp Server Pool Settings - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack

DHCP Server Exclude Address Settings

The following window will allow the user to set an IP address, or a range of IP addresses that are NOT to be included in the range
of IP addresses that the Switch will allot to clients requesting DHCP service. To set an IP address or range of IP addresses, enter
the Begin Address of the range and then the End Address of the range and click Apply. Set address ranges will appear in the
DHCP Exclude Address Table in the bottom half of the window, as shown below.
To view this window, click Administration > DHCP Server > DHCP Server Exclude Address Settings, as shown below.
The following parameters may be configured:
Parameter Description
Begin Address Enter the starting IP address of the range of IP addresses to be excluded from the DHCP pool.
End Address Enter the final IP address of the range of IP addresses to be excluded from the DHCP pool.
Click Apply to implement changes made. To remove any entry, click the corresponding
Clear All.

DHCP Server Pool Settings

The following windows will allow users to create and then set the parameters for the DHCP Pool of the switch's DHCP server.
To view the following window, click Administration > DHCP Server > DHCP Server Pool Settings, as shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 76 Create DHCP Excluded Address window
71
button. To delete all the entries, click