Traffic Segmentation - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack
flow to the CPU by dynamically allotting an even bandwidth to all traffic flows.
Switch, and will stop receiving all unnecessary broadcast IP packets, until the storm has
subsided.
The default setting is Fuzzy mode.
Safeguard Displays the current mode of the CPU Utilization Settings.
Engine Current
Status
Click Apply to implement the changes.

Traffic Segmentation

Traffic segmentation is used to limit traffic flow from a single port to a group of ports. This method of segmenting the flow of
traffic is similar to using VLANs to limit traffic, but is more restrictive. It provides a method of directing traffic that does not
increase the overhead of the Master switch CPU.
To view this window, click Security > Traffic Segmentation, as shown below.
Click the Setup button to open the Setup Forwarding Ports window, as shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Strict – If selected, this function will stop accepting all ARP packets not intended for the
Figure 6 - 64 Current Traffic Segmentation Table window
331