Layer 2 Protocol Tunneling Settings - D-Link xStack DGS-3420 Series Reference Manual

Xstack dgs-3420 series layer 2 managed stackable gigabit switch web ui reference guide
Hide thumbs Also See for xStack DGS-3420 Series:
Table of Contents

Advertisement

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
Action
SVID (1-4094)
Priority
Source MAC
Source Mask
Destination MAC
Destination Mask
Source IP
Source IP Mask
Destination IP
Destination IP Mask
L4 Source Port
L4 Destination Port
Outer VID List
802.1p
IP Protocol
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes and return to the previous page.
After clicking the Show Match button, the following page will be available:
Click the Show All VLAN Translation Profile button to the return to the main page.

Layer 2 Protocol Tunneling Settings

This window is used to configure the layer 2 Protocol tunneling port settings.
Select the action that will be taken here. Options to choose from are Add and Replace. Add
specifies to add a tag for the assigned S-VLAN before the Outer-VLAN tag. If there is an S-
TAG in the packet, this rule will not take effect. Replace specifies to replace the outer-VLAN
ID in the tag by the SVID. If there is no TAG in the packet, this rule will not take effect.
Enter the S-VLAN ID to be assigned to the matched packet.
Select the 802.1p priority of the S-Tag. If the priority is not specified, the 802.1p priority of
S-Tag will be assigned by the default procedure.
Enter the source MAC address or MAC address range for the match.
Enter the source MAC address mask.
Enter the destination MAC address or MAC address range for the match.
Enter the destination MAC address mask.
Enter the source IPv4 address or IPv4 subnet for the match.
Enter the source IPv4 address mask used.
Enter the destination IPv4 address or IPv4 subnet for the match.
Enter the destination IPv4 address mask used.
Enter the Layer 4 source port ID for the match.
Enter the Layer 4 destination port ID for the match.
Enter the packet's outer-VID for the match.
Select the packet's 802.1p priority for the match.
Enter the IP protocol number used. This value must be between 0 and 255.
Figure 4-34 VLAN Translation Profile List window (Show Match)
107

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgs-3420-28sc

Table of Contents