D-Link DGS-3427 - xStack Switch - Stackable Product Manual page 174

x Stack
Click the corresponding Modify button in the IGMP Snooping Settings table to open the window, as shown below.
The following parameters may be viewed or modified:
Parameter
VID
VLAN Name
Query Interval (1-65535)
Max Response Time (1-25)
Robustness Variable (1-255)
Last Member Query Interval
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 3 - 29 IGMP Snooping Settings – Edit window
Description
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
The Query Interval field is used to set the time (in seconds) between transmitting
IGMP queries. Entries between 1 and 65535 seconds are allowed. Default = 125.
This determines the maximum amount of time in seconds allowed before sending an
IGMP response report. The Max Response Time field allows an entry between 1 and
25 (seconds). Default = 10.
Adjust this variable according to expected packet loss. If packet loss on the VLAN is
expected to be high, the Robustness Variable should be increased to accommodate
increased packet loss. This entry field allows an entry of 1 to 255. Default = 2.
This field specifies the maximum amount of time between group-specific query
165