Impb Port Settings - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack
The DHCP Snoop State field will enable and disable the DHCP Snooping option.
To view this window, click Security > IP-MAC-Port Binding > IMPB Global Settings:
The following parameters can be set:
Parameter
Trap / Log
DHCP Snoop (IPv4)
DHCP Snoop (IPv6)
ND Snoop
Click Apply to implement the settings made.

IMPB Port Settings

This window is used to configure IMP settings on a port basis.
Select a port or a range of ports with the From Port and To Port fields. Enable or disable the port with Strict or Loose State, enable
or disable Allow Zero IP and Forward DHCP Packet fields, and configure the port's Max IMPB entry.
To view this window, click Security > IP-MAC-Port Binding > IMPB Port Settings, as shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 6 - 9 IMPB Global Settings window
Description
This field will enable and disable the sending of trap log messages for IP-MAC binding. When
enabled, the Switch will send a trap log message to the SNMP agent and the Switch log
when an ARP packet is received that doesn't match the IP-MAC binding configuration set on
the Switch.
Use the pull-down menu to enable or disable the DHCP snooping state (IPv4) for IP-MAC-
port binding.
Use the pull-down menu to enable or disable the DHCP snooping state (IPv6) for IP-MAC-
port binding.
Use the pull-down menu to enable or disable the ND snooping state for IP-MAC-port binding.
283