Configuring An Aggregate Interface; Configuring The Description Of An Aggregate Interface Or Subinterface - HP A6600 Configuration Manual

To do...
4. Configure the
aggregation group to
work in dynamic
aggregation mode
5. Exit to system view
6. Enter Layer 3 Ethernet
interface view
7. Assign the Ethernet
interface to the
aggregation group
8. Assign the port an
aggregation priority
9. Set the LACP timeout
interval on the port to the
short timeout interval (1
second)

Configuring an aggregate interface

Perform the following configurations on an aggregate interface:

Configuring the description of an aggregate interface or subinterface

•
Configuring the MTU of a Layer 3 aggregate interface or subinterface
•
Specifying a card to process or forward traffic for a Layer 3 aggregate interface
•
Enabling link state traps for an aggregate interface
•
Shutting down an aggregate interface
•
In addition to the preceding configurations, most of the configurations that can be performed on Layer 2
or Layer 3 Ethernet interfaces can also be performed on Layer 2 or Layer 3 aggregate interfaces.
Configuring the description of an aggregate interface or
subinterface
Configure the description of an aggregate interface for administration purposes such as describing the
purpose of the interface.
To configure the description of an aggregate interface or subinterface:
To do...
1. Enter system view
Use the command...
link-aggregation mode dynamic
quit
interface interface-type
interface-number
port link-aggregation group
number
link-aggregation port-priority
port-priority
lacp period short
Use the command...
system-view
21
Remarks
Required.
By default, an aggregation group works
in static aggregation mode.
—
Required.
Repeat these two steps to assign more
Layer 3 Ethernet interfaces to the
aggregation group.
Optional.
By default, the aggregation priority of a
port is 32,768.
Changing the aggregation priority of a
port may affect the aggregation state of
ports in the dynamic aggregation group.
Optional.
By default, the LACP timeout interval on a
port is the long timeout interval (30
seconds).
Remarks
—