Opening And Closing The Hp Netserver; Introduction; Tools Required - HP LC2000r - NetServer - 128 MB RAM Installation Manual

3 Opening and Closing the HP
NetServer

Introduction

This chapter describes removing and replacing the covers of the rack-mount HP
NetServer LH 6000r and the pedestal HP NetServer LH 6000. If the NetServer is
not currently installed in a rack, skip to step 6 for the LH 6000r in the following
section, "Removing the LH 6000r Rack Mount Covers."
WARNING

Tools Required

l
Torx 25 Driver (for rack access only)
l
Anti-static service kit (3M 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.
Shut down the operating system before removing covers.
Disconnect power cords to avoid exposure to high energy
levels that may cause burns when parts are short-circuited by
metal objects, such as tools or jewelry. Disconnect telephone
cables to avoid exposure to shock hazard from telephone
ringing voltages.
Wear a grounded wrist strap and use a static-dissipating work
surface when handling NetServer components.
Note that the power switch does not turn off the standby
power. (Standby power is on when the LCD is backlighted.)
Disconnect the power cords to turn off standby power.
29