Replacing The Lcm/Rcm - Spectra Logic T-Series Spectra T120 User Manual

Replacing the LCM/RCM

1. Shut down power to the library.
(Press and hold down the power button on the front of the library until the
button flashes; it takes a few minutes to gradually shut down components.)
2. Go to the rear of the library and locate the LCM/RCM. (If necessary, see
Component Location on page 7.)
3. Use a #2 Phillips screwdriver to loosen the two LCM/RCM screws, located on the
top and bottom of the LCM/RCM (Figure 6-2).
4. Pull outward on the handle (Figure 6-3).
5. Place the old LCM/RCM on a clean work space.
Chapter 6. LCM/RCM Replacement
Figure 6-2 The LCM/RCM screws.
Figure 6-3 Pulling out the LCM/RCM.
19