After You Replace The Lcm - Spectra Logic T-Series Spectra T200 Release Note

Assisted Self-Maintenance Guide Updates

After You Replace the LCM

After you replace an LCM and the library restarts, restore the partition
definitions and library configuration settings using one of the following
methods.
Do not install the compact flash card from the LCM you replaced unless directed to
Caution
do so by SpectraGuard Support. Installing a corrupted compact flash card can
cause the new LCM to fail.
34
Release Notes
All AutoSupport Profile information (Maintenance > AutoSupport
> Manage Profile)
AutoSupport Contract number
Site address
Contact Name, Phone and email listed.
User names and passwords (Security > Edit Users)
All exported encryption keys and their passwords
If SpectraGuard Support directs you to do so, remove the card from the
LCM you replaced and install it in the new LCM compact flash slot as
described in the Spectra T200 & T380 Assisted Self Maintenance Guide.
Use an auto-save configuration file you previously saved to a USB
storage device to restore the library configuration and MLM database.
Refer to the Spectra T200, T380, and T680 User Guide for detailed
information.
If you do not have an auto-save configuration file available, refer to the
Spectra T200, T380, and T680 User Guide for information about using the
advanced utilities to restore a previously saved library configuration
file. Refer to the Spectra T200, T380, and T680 User Guide for detailed
information about restoring the MLM database using a previously
saved backup. If necessary, update the configuration to the most
current settings after the restore is complete.
If you do not have any backups of the library configuration, re-enter all
of the configuration settings using the information you recorded in
Before You Begin on page
User Guide for detailed instructions.
Refer to the Spectra T200, T380, and T680 User Guide for information
about reimporting encryption keys.
33). Refer to the Spectra T200, T380, and T680
91010001