4. If your new robotic assembly includes a T8 Torx screw and L-shaped key, use it
to screw in the supplied Torx screw to attach the HAX bracket to the upper HAX
belt at the top of the library in Figure 7-31. Otherwise, in that same location, use
a #2 Phillips screwdriver and the screw removed in an earlier step. A label may
point to the location in which to place the screw.
Figure 7-31 Tightening the T8 Torx screw using the Torx L-key
(outlined in white) if available; remove the shipping screw after
the bracket is attached. To clearly show the Torx screw position in
this picture, the shipping screw has already been removed.
5. Remove the shipping screw (shown in Figure 7-29) and return it to its original
location near the front of the robotic assembly.
Chapter 7. Robotic Assembly Replacement
42