Advertisement
Quick Links
Advertisement
Related Manuals for Spectra Logic T120 LIBRARY
Summary of Contents for Spectra Logic T120 LIBRARY
- Page 1 T120 L PECTRA IBRARY Front Panel LED Board Replacement Instructions SpectraLogic.com...
- Page 2 THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, BOTH OF WHICH ARE EXPRESSLY DISCLAIMED. In no event shall Spectra Logic be liable for any loss of profits, loss of business, loss of use or data, interruption of business, or for indirect, special, incidental or consequential damages of any kind, even if Spectra Logic has been advised of the possibility of such damages arising from any defect or error.
- Page 3 Replacing a Front Panel LED Board These instructions describe replacing a front panel LED board in a Spectra T120 library.The light in the LED board is used to light the interior of the library. REPARE FOR THE EPLACEMENT Replacing this component takes about fifteen minutes. Follow the guidelines in these sections as you prepare for the replacement procedure.
- Page 4 Discontinuing Backups Backups cannot run during this procedure since the library must be powered down. Use your backup software to stop any backups running to the library. Restart any backup processes after you complete the replacement procedure and run diagnostics to ensure that the library is operational.
- Page 5 Follow these steps to access the LED board. 1. Unlock and open the library’s front door. 2. Manually extend the E/E port by pulling it out from the bottom. Pull out from bottom Figure 2 Manual E/E port extension. Spectra T120 Library July 2009...
- Page 6 3. Using a #2 Phillips screwdriver, loosen the three thumb screws securing the interior cover panel to the chassis. Interior cover panel Loosen three thumb screws using a #2 This screw Phillips screwdriver. hidden in this view Figure 3 Thumb screw locations. Note: Figure 3 shows the E/E port in the closed position to better show the thumb screw locations.
-
Page 7: Led Board
1. Using a #1 Phillips screwdriver, remove the two screws securing the board to the mounting plate and set them aside. 2. Disconnect the connector and set the board aside for disposal. 3. Unpack the replacement board. Spectra T120 Library July 2009... - Page 8 4. Connect the cable to the connector on the LED board. This view—looking at the back side of the interior cover panel—shows the LED board unscrewed from its mounting plate and tilted out with the cable connected. Mounting holes Mounting plate LED board (tilted out) Cable connector...