Spectra Logic T-Series Spectra T120 User Manual page 36

2. Align the bearings underneath the picker unit, positioning the unit as shown in
Figure 7-20.When it is oriented properly, four screws holes are aligned as shown
in Figure 7-21.
Figure 7-20 Placing the picker unit onto its base, on top of the two
bearings, oriented so that you can attach the lower HAX belt bracket.
3. Use a #1 Phillips screwdriver to screw in four screws.
4. Rotate the VAX column to reveal the four screw holes on the opposite side, then
screw in the screws.
Chapter 7. Robotic Assembly Replacement
Figure 7-21 Four screws on one side of the picker.
36