Spectra Logic T-Series Spectra T120 User Manual page 41

Aligning the VAX
1. Locate the shipping screw located near the HAX belt pulley on the assembly
base, then use a #2 Phillips screwdriver to unscrew it.
Figure 7-28 The shipping screw.
2. Identify the plate at the top of the assembly, then rotate the HAX belt pulley
until the holes in the plate align with the holes in the top bracket. Insert the
shipping screw and use a #2 Phillips screwdriver to tighten the screw. This helps
properly align the vertical axis.
Figure 7-29 The upper HAX bracket with the shipping
screw secured in place for alignment.
3. Rotate the top HAX rod to align the top HAX belt bracket as shown in
Figure 7-30.
Chapter 7. Robotic Assembly Replacement
Figure 7-30 The upper HAX bracket with the shipping
screw in place and the upper HAX belt bracket ready to attach.
41