Spectra Logic T-Series Spectra T120 User Manual page 37

Attaching the Bracket and Cable
1. Use a #2 Phillips screwdriver to screw in the two screws attaching the HAX belt
bracket to the picker base. (Note that older style pickers attach to the lower
HAX belt bracket in a different orientation.)
Figure 7-22 Attaching the bracket with screws.
2. Attach the ribbon cable. In the newer style of picker, two ribbon cables are in
use. In the newer models, attach the lower ribbon cable, routing it properly and
making sure it isn't bent. Seat the ribbon cable plug into the connector, pressing
the tabs toward the connector so that the cable fits securely into the connector.
Figure 7-23 The ribbon cable plug and connector, and the top and bottom ribbon cables.
3. In the newer models, repeat with the remaining ribbon cable.
4. Remove the small binder clip used in Step 4 on page 34. The picker head
gradually descends.
Chapter 7. Robotic Assembly Replacement
37