Replacing The T200, T380, Or T680 Lcd; Repare For The Eplacement; Power Off The Library - Spectra Logic Tape Series Instruction Manual

Replacing the T200, T380, or T680 LCD

This chapter describes replacing the LCD in a Spectra T200, T380, or T680
library.
P
REPARE FOR THE
Before beginning this replacement procedure, make sure that you address
the requirements in Before You Begin on page
in the following sections.

Power Off the Library

1.
2. Power off the library from the front panel.
3. Make sure that the transporter is idle.
The relative locations of the components and the procedures are
Note:
the same for all three libraries unless otherwise indicated.
R
EPLACEMENT
Prepare the library to be powered off, as described in Prepare to Power
Off the Library on page
Refer to the Spectra T200, T380 & T680 Libraries User Guide for
Note:
instructions if the BlueScale Soft Power option is enabled.
a. Press the front panel power button for approximately six seconds or
until the button's LED starts flashing.
b. Wait for power‐off sequence to complete. It takes from one minute
to five minutes (depending on the library) while the library allows
applications to shut down gracefully.
5 and then perform the steps
7.
9