Removing The Robotic Assembly - Spectra Logic T-Series Spectra T120 User Manual

Removing the Robotic Assembly

Preparing to Remove the Assembly
1. Disconnect the motor control cable from the motor control board at the front of
the library. Note the location of this cable; when you remove the robotic
assembly from the library, a second person will hold this cable out of the way.
2. Turn the horizontal axis (HAX) belt pulley to move the entire assembly forward
three-quarters of the way to the front of the library.
Caution:
Do not move the entire robotic assembly by hand; doing so may
result in vertical axis (VAX) misalignment.
Chapter 7. Robotic Assembly Replacement
Figure 7-6 The motor control cable.
Figure 7-7 Turning the HAX belt pulley.
27