Upgrading A Loader - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Manual Upgrade on a Dual Supervisor Module Switch
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
image name: m9500-sf1ek9-kickstart-mzg.1.0.3.bin
kickstart:
loader:
compiled:
Note
Compare the running system image and the new image by issuing the show install all impact command.
Step 6

Upgrading a Loader

The install module slot# of the supervisor module loader command upgrades the (boot) loader.
If the loader is upgraded, you need to reboot to make the new loader effective. You can schedule the
Note
reboot at a convenient time so traffic is not impacted.
Before issuing this command, be sure to read the release notes to verify compatibility issues between the
Caution
loader and the kickstart or system images.
To upgrade the loader on either the active or standby supervisor module, follow these steps:
Use the show version command to verify the version on the active and standby supervisor modules.
Step 1
switch# show version
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2009, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
Cisco Systems, Inc. and/or other third parties and are used and
distributed under license. Some parts of this software are covered
under the GNU Public License. A copy of the license is available
at http://www.gnu.org/licenses/gpl.html.
Software
BIOS:
loader:
kickstart: version 2.0(1)
system:
BIOS compile time:
kickstart image file is: bootflash:///m9500-sf1ek9-kickstart-mzg.2.0.0.6.bin
kickstart compile time:
system image file is:
system compile time:
Hardware
RAM 1024584 kB
Cisco MDS 9000 Family CLI Configuration Guide
8-28
version 1.0(3)
version 1.0(3)
2/12/2003 11:00:00
A verification failed message is generated when you use a Cisco MDS 9500 Series image on a
Cisco MDS 9200 Series switch or a Cisco MDS 9200 Series image on a Cisco MDS 9500 Series
switch. Be sure to verify the right image.
version 1.0.8
version 1.1(2) <-------------------------current running version
version 2.0(1)
08/07/03
10/25/2010 12:00:00
bootflash:///m9500-sf1ek9-mzg.2.0.0.6.bin
10/25/2020 12:00:00
Chapter 8 Software Images
OL-18084-01, Cisco MDS NX-OS Release 4.x