Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 302

Identifying Module LEDs
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 12-5
LED
Link
1. The speed LED is only present on the 2-Gbps Fibre Channel switching modules.
Table 12-6
Table 12-6
LED
Status
System
MGMT 10/100
Ethernet Link
LED
MGMT 10/100
Ethernet
Activity LED
Cisco MDS 9000 Family CLI Configuration Guide
12-10
LEDs for the Cisco MDS 9200 Series Supervisor Modules (continued)
Status Description
Solid green Link is up.
Solid Link is disabled by software.
yellow
Flashing A fault condition exists.
yellow
Off No link.
describes the LEDs for the Cisco MDS 9200 Series interface module.
LEDs on the Cisco MDS 9200 Series Interface Module
Status Description
Green All diagnostics pass. The module is operational (normal initialization
sequence).
Orange The module is booting or running diagnostics (normal initialization
sequence).
or
The inlet air temperature of the system has exceeded the maximum system
operating temperature limit (a minor environmental warning). To ensure
maximum product life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red The diagnostic test failed. The module is not operational because a fault
occurred during the initialization sequence.
or
he inlet air temperature of the system has exceeded the safe operating
T
temperature limits of the card (a major environmental warning). The card
has been shut down to prevent permanent damage.
Green All chassis environmental monitors are reporting OK.
Orange The power supply failed or the power supply fan failed.
or
Incompatible power supplies are installed.
or
The redundant clock failed.
Red The temperature of the supervisor module exceeded the major threshold.
Green Link is up.
Off No link.
Green Traffic is flowing through port.
Off No link or no traffic.
Chapter 12 Managing Modules
OL-18084-01, Cisco MDS NX-OS Release 4.x