Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 162

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Step 5 Enter no (no is the default) if you do not wish to create additional accounts.
Create another login account (yes/no) [no]: no
Configure the read-only or read-write SNMP community string.
Step 6
a.
b.
c.
Enter a name for the switch.
Step 7
Note
Enter the switch name: switch_name
Enter no (yes is the default) at the configuration prompt to configure out-of-band management.
Step 8
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: no
Step 9 Enter yes (yes is the default) to configure the default gateway.
Configure the default-gateway: (yes/no) [y]: yes
a.
Enter yes (no is the default) to configure advanced IP options such as in-band management, static routes,
Step 10
default network, DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: yes
a.
b.
c.
d.
e.
Cisco MDS 9000 Family CLI Configuration Guide
5-12
Enter no (no is the default) to avoid configuring the read-only SNMP community string.
Configure read-only SNMP community string (yes/no) [n]: no
Enter no (no is the default) to configure the read-only SNMP community string.
Configure read-only SNMP community string (yes/no) [n]: yes
Enter the SNMP community string.
SNMP community string: snmp_community
The switch name is limited to 32 alphanumeric characters. The default is switch.
Enter the default gateway IP address.
IP address of the default gateway: default_gateway
Enter yes (no is the default) at the in-band management configuration prompt.
Continue with in-band (VSAN1) management configuration? (yes/no) [no]: yes
Enter the VSAN 1 IPv4 address.
VSAN1 IPv4 address: ip_address
Enter the IPv4 subnet mask.
VSAN1 IPv4 net mask: subnet_mask
Enter no (yes is the default) to enable IPv4 routing capabilities.
Enable ip routing capabilities? (yes/no) [y]: no
Enter no (yes is the default) to configure a static route.
Configure static route: (yes/no) [y]: no
Enter no (yes is the default) to configure the default network.
Configure the default-network: (yes/no) [y]: no
Enter no (yes is the default) to configure the DNS IPv4 address.
Chapter 5 Initial Configuration
OL-18084-01, Cisco MDS NX-OS Release 4.x