Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 159

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Step 15 Enter the SSH key type (see the
would like to generate.
Type the SSH key you would like to generate (dsa/rsa)? rsa
Enter the number of key bits within the specified range.
Step 16
Enter the number of key bits? (768 to 2048): 2048
Step 17 Enter yes (no is the default) to configure the NTP server.
Configure NTP server? (yes/no) [n]: yes
a.
Enter shut (shut is the default) to configure the default switch port interface to the shut (disabled) state.
Step 18
Configure default switchport interface state (shut/noshut) [shut]: shut
Note
Step 19 Enter on (on is the default) to configure the switch port trunk mode.
Configure default switchport trunk mode (on/off/auto) [on]: on
Step 20 Enter yes (yes is the default) to configure the switchport mode F.
Configure default switchport mode F (yes/no) [n]: y
Enter on (off is the default) to configure the PortChannel auto-create state.
Step 21
Configure default port-channel auto-create state (on/off) [off]: on
Enter permit (deny is the default) to deny a default zone policy configuration.
Step 22
Configure default zone policy (permit/deny) [deny]: permit
Permits traffic flow to all members of the default zone.
If you are executing the setup script after issuing a write erase command, you explicitly must change
Note
the default zone policy to permit for VSAN 1 after finishing the script using the following commands:
switch# config t
switch(config)# zone default-zone permit vsan 1
Enter yes (no is the default) to enable a full zone set distribution (see the
Step 23
on page
Enable full zoneset distribution (yes/no) [n]: yes
Overrides the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Enter the NTP server IPv4 address.
NTP server IP address: ntp_server_IP_address
The management ethernet interface is not shut down at this point—only the Fibre Channel,
iSCSI, FCIP, and Gigabit Ethernet interfaces are shut down.
24-13).
"Overwriting a Generated Key-Pair" section on page
Cisco MDS 9000 Family CLI Configuration Guide
Initial Setup Routine
32-16) that you
"Zone Set Distribution" section
5-9