Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 163

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
f.
Enter no (no is the default) to disable the Telnet service.
Step 11
Enable the telnet service? (yes/no) [y]: no
Enter yes (yes is the default) to enable the SSH service.
Step 12
Enabled SSH service? (yes/no) [n]: yes
Enter the SSH key type (see the
Step 13
would like to generate.
Type the SSH key you would like to generate (dsa/rsa)? rsa
Enter the number of key bits within the specified range.
Step 14
Enter the number of key bits? (768 to 2048): 2048
Enter no (no is the default) to configure the NTP server.
Step 15
Configure NTP server? (yes/no) [n]: no
Enter shut (shut is the default) to configure the default switch port interface to the shut (disabled) state.
Step 16
Configure default switchport interface state (shut/noshut) [shut]: shut
Note
Enter auto (off is the default) to configure the switch port trunk mode.
Step 17
Configure default switchport trunk mode (on/off/auto) [off]: auto
Enter yes (yes is the default) to configure the switchport mode F.
Step 18
Configure default switchport mode F (yes/no) [n]: y
Enter off (off is the default) to configure the PortChannel auto-create state.
Step 19
Configure default port-channel auto-create state (on/off) [off]: off
Enter deny (deny is the default) to deny a default zone policy configuration.
Step 20
Configure default zone policy (permit/deny) [deny]: deny
Denies traffic flow to all members of the default zone.
Note
Enter no (no is the default) to disable a full zone set distribution (see the
Step 21
on page
OL-18084-01, Cisco MDS NX-OS Release 4.x
Configure the DNS IP address? (yes/no) [y]: no
Enter no (no is the default) to skip the default domain name configuration.
Configure the default domain name? (yes/no) [n]: no
The management Ethernet interface is not shut down at this point—only the Fibre Channel,
iSCSI, FCIP, and Gigabit Ethernet interfaces are shut down.
If you are executing the setup script after issuing a write erase command, you must explicitly
change the default zone policy to permit for VSAN 1 after finishing the script using the
following commands:
switch# config t
switch(config)# zone default-zone permit vsan 1
24-13).
"Overwriting a Generated Key-Pair" section on page
Cisco MDS 9000 Family CLI Configuration Guide
Initial Setup Routine
32-16that you
"Zone Set Distribution" section
5-13