Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 157

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
b.
Enter yes (yes is the default) to create an SNMPv3 account.
Step 7
Configure SNMPv3 Management parameters (yes/no) [y]: yes
a.
b.
Note
Step 8 Enter yes (no is the default) to configure the read-only or read-write SNMP community string.
Configure read-only SNMP community string (yes/no) [n]: yes
a.
Enter a name for the switch.
Step 9
Note
Enter the switch name: switch_name
Enter yes (yes is the default) to configure out-of-band management.
Step 10
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
a.
b.
Enter yes (yes is the default) to configure the IPv4 default gateway (recommended).
Step 11
Configure the default-gateway: (yes/no) [y]: yes
a.
Enter yes (no is the default) to configure advanced IP options such as in-band management, static routes,
Step 12
default network, DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: yes
a.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Enter the user password.
Enter the password for user_name: user-password
Enter the user name (admin is the default).
SNMPv3 user name [admin]: admin
Enter the SNMPv3 password (minimum of eight characters). The default is admin123.
SNMPv3 user authentication password: admin_pass
By default, if the admin password is at least eight characters, then the SNMP authentication
password is the same as the admin password (at least eight characters). If the admin password is
less than eight characters, then you need to provide a new password for SNMP. The admin
password can have a minimum of one character, but the SNMP authentication password must
have a minimum of eight characters.
Enter the SNMP community string.
SNMP community string: snmp_community
The switch name is limited to 32 alphanumeric characters. The default is switch.
Enter the mgmt0 IPv4 address.
Mgmt0 IPv4 address: ip_address
Enter the mgmt0 IPv4 subnet mask.
Mgmt0 IPv4 netmask: subnet_mask
Enter the default gateway IPv4 address.
IPv4 address of the default-gateway: default_gateway
Enter no (no is the default) at the in-band management configuration prompt.
Cisco MDS 9000 Family CLI Configuration Guide
Initial Setup Routine
5-7