Using The Setup Command; Accessing The Switch - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Using the setup Command

To make changes to the initial configuration at a later time, you can issue the setup command in EXEC
mode.
switch# setup
---- Basic System Configuration Dialog ----
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system.
*Note: setup always assumes a predefined defaults irrespective
of the current system configuration when invoked from CLI.
Press Enter incase you want to skip any dialog. Use ctrl-c at anytime
to skip away remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): yes
The setup utility guides you through the basic configuration process.

Accessing the Switch

After initial configuration, you can access the switch in one of three ways (see
•
•
•
OL-18084-01, Cisco MDS NX-OS Release 4.x
Serial console access—You can use a serial port connection to access the CLI.
In-band IP (IPFC) access—You can use Telnet or SSH to access a switch in the Cisco MDS 9000
Family or use SNMP to connect to a Cisco MDS 9000 Fabric Manager application.
Out-of-band (10/100/1000 BASE-T Ethernet) access—You can use Telnet or SSH to access a switch
in the Cisco MDS 9000 Family or use SNMP to connect to a Cisco MDS 9000 Fabric Manager
application. Supervisor-1 modules support 10/100 BASE-T Ethernet and Supervisor-2 modules
support 10/100/1000 BASE-T Ethernet.
To use the Cisco Fabric Manager, refer to the Cisco MDS 9000 Family Fabric Manager
Note
Configuration Guide.
Cisco MDS 9000 Family CLI Configuration Guide
Accessing the Switch
Figure 5-2):
5-15