Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 160

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Note
Enter enhanced (basic is the default) to configure default-zone mode as enhanced.
Step 24
Configure default zone mode (basic/enhanced) [basic]: enhanced
Overrides the switch-wide default zone mode as enhanced.
Note
Step 25 Enter no (no is the default) if you are satisfied with the configuration.
The following configuration will be applied:
username admin password admin_pass role network-admin
username user_name password user_pass role network-admin
snmp-server community snmp_community ro
switchname switch
interface mgmt0
ip routing
ip route dest_prefix dest_mask dest_address
ip default-network dest_prefix
ip default-gateway default_gateway
ip name-server name_server
ip domain-name domain_name
telnet server disable
ssh key rsa 2048 force
ssh server enable
ntp server ipaddr ntp_server
system default switchport shutdown
system default switchport trunk mode on
system default switchport mode F
system default port-channel auto-create
zone default-zone permit vsan 1-4093
zoneset distribute full vsan 1-4093
system default zone mode enhanced
Would you like to edit the configuration? (yes/no) [n]: no
Enter yes (yes is default) to use and save this configuration:
Step 26
Use this configuration and save it? (yes/no) [y]: yes
Cisco MDS 9000 Family CLI Configuration Guide
5-10
If you are executing the setup script after issuing a write erase command, you must explicitly
change the default zone policy to permit for VSAN 1 after finishing the script using the
following commands:
switch# config t
switch(config)# zoneset distribute full vsan 1
If you are executing the setup script after issuing a write erase command, you must explicitly
change the default zoning mode to enhanced for VSAN 1 after finishing the script using the
following commands:
switch# config t
switch(config)# zone mode enhanced vsan 1
ip address ip_address subnet_mask
no shutdown
Chapter 5 Initial Configuration
OL-18084-01, Cisco MDS NX-OS Release 4.x