Setting The Interface Administrative State; Configuring Interface Modes - Cisco Nexus 5000 Series Configuration Manual

Configuring Fibre Channel Interfaces
DETAILED STEPS
Command or Action
Step 1
switch# configuration terminal
Step 2
switch(config)# interface { fc slot/port - port [ , fc slot/port
- port ] | vfc vfc-id - vfc-id [ , vfc vfc-id - vfc-id ] }

Setting the Interface Administrative State

To gracefully shut down an interface, perform this task:
To enable traffic flow, perform this task:
SUMMARY STEPS
1. switch# configuration terminal
2. switch(config)# interface {fc slot/port}|{vfc vfc-id}
3. switch(config-if)# shutdown
DETAILED STEPS
Command or Action
Step 1
switch# configuration terminal
Step 2
switch(config)# interface {fc slot/port}|{vfc
vfc-id}
Step 3 switch(config-if)# shutdown

Configuring Interface Modes

SUMMARY STEPS
1. configure terminal
2. switch(config) # interface vfc vfc-id}
3. switch(config-if) # switchport mode {E|NP}
OL-27583-01
Purpose
Enters configuration mode.
Selects a Fibre Channel interface and enters interface
configuration mode.
Gracefully shuts down the interface and administratively
disables traffic flow (default).
Cisco Nexus 5000 Series NX-OS SAN Switching Configuration Guide, Release 5.2(1)N1(1)
Configuring Fibre Channel Interfaces
Purpose
Enters configuration mode.
Selects the range of Fibre Channel interfaces and
enters interface configuration mode.
17