Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 58

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 1-1 New and Changed Features for Cisco MDS NX-OS Release 4.x (continued)
Feature
Embedded Event
Manager (EEM)
Software change
Feature configuration
commands
Initial Setup Routine
Crossbar management
with Fabric 2 modules
SSM (SSI) Upgrade
Delay
Generation 3 48-Port,
24-Port, and 4/44-Port
8-Gbps Fibre Channel
modules configuration
Scheduler Job
Configuration
SAN Device
Virtualization
DPVM configuration
Call Home
IP Static Peers for CFS
over IP
MSM 18+4 and MDS
9222i support
Cisco MDS 9000 Family CLI Configuration Guide
lviii
New and Change Topics
New chapter on configuring Embedded Event
Manager (EEM) has been added.
As of Release 4.1(1b) and later, the MDS
SAN-OS software is changed to MDS NX-OS
software. The earlier releases are unchanged and
all references are retained.
feature { cimserver | cluster | crypto | dpvm |
fabric-binding | fcip | fcrxbbcredit | fcsp | ficon
| iscsi | ivr | npiv | port-security | port-track |
san-ext-tuner | scheduler | sdv | sme | ssh |
tacacs+ | telnet } command replaces the existing
enable commands. For example, enable fcip is
deprecated and replaced by feature fcip. All the
other feature configuration commands are
unchanged.
Updated initial switch bootup configuration
steps.
Updated crossbar management section for
Generation 3 modules.
Added a topic on SSI upgrade delay timer
configuration for SSMs and MSMs.
Added configuration guidelines that includes port
groups, port rate modes, BB_credit buffer
allocation, port speed configuration,
over-subscription ratio restrictions, combining
with earlier generation modules, upgrade and
downgrade considerations, crossbar
management, port channel interface
configuration, example configurations, and
default settings.
Updated the scheduler job configuration
command syntax and guidelines.
Updated with automatic failover and fallback
configuration information.
Added DPVM configuration commands and
guidelines
Added the HTTPS support for Call Home.
Added IP static peers configuration steps for CFS
distribution over IP.
Added SSI support on MSM 18+4, and MDS
9222i.
New and Changed Information
Changed
in
Release Where Documented
4.1(3) Chapter 54, "Configuring the
Embedded Event Manager"
4.1(1b) All chapters
4.1(1b) Chapter 2, "Before You Begin"
related chapters
4.1(1b) Chapter 5, "Initial Configuration"
4.1(1b) Chapter 11, "Managing System
Hardware"
4.1(1b) Chapter 12, "Managing Modules"
4.1(1b) Chapter 15, "Configuring
Generation 2 and Generation 3
Switching Modules"
4.1(1b) Chapter 19, "Scheduling
Maintenance Jobs"
4.1(1b) Chapter 21, "SAN Device
Virtualization"
4.1(1b) Chapter 22, "Creating Dynamic
VSANs"
4.1(1b) Chapter 53, "Configuring Call
Home"
4.1(1b) Chapter 7, "Using the CFS
Infrastructure"
4.1(1b) Chapter 12, "Managing Modules"
OL-18084-01, Cisco MDS NX-OS Release 4.x
and