Managing Snmp Mibs And Snmp Traps; Configuring Phone Security Profile Information; Saving Your Settings; Adding A New Phone Security Profile For Cts - Cisco CTS-500 Configuration Manual

Configuring Phone Security Profile Information

Table 1-11 Cisco TelePresence SNMP Trap Receiver Parameters (continued)
Field
SNMP (v3) Privacy Password
SNMP(v2c) Community String

Managing SNMP MIBs and SNMP Traps

See
managing SNMP MIBs and Traps.

Saving Your Settings

When you have finished making changes to the parameters in the Phone Configuration window, click
Apply Config then Save. The Apply Configuration Information window appears showing the selected
device name.
Note You must save the configuration before continuing. When you click Apply Config, the device might go
through a restart. When restart is initiated, connected calls will be preserved but calls in progress may
be dropped.
Configuring Phone Security Profile Information
This section describes how to create and configure a phone security profile for a Cisco TelePresence
device using Cisco Unified CM. This section contains the following tasks:
•
•

Adding a New Phone Security Profile for CTS

To add a new phone security profile for CTS, follow these steps:
Step 1 Log in to the Cisco Unified CM Administration interface.
Choose System > Security Profile and click Phone Security Profile.
Step 2
Click the Add New button at the bottom of the window. The Phone Security Profile Configuration
Step 3
window appears.
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
1-26
Chapter 1
Required? Setting
Yes SNMP v3 only. Default password is snmppassword1.
•
•
Note
Yes Community string supported by the Trap Receiver. This field is only used for
SNMP v2c.
Default is communityString. Maximum length: 64
"MIBs, RFCs, and SNMP Trap Messages for the Cisco TelePresence System"
Adding a New Phone Security Profile for CTS, page 1-26
Configuring the Phone Security Profile, page 1-27
Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
Maximum field length is 32 characters.
Minimum field length is 8 characters.
Each algorithm requires different privacy and authentication
passwords.
for information about
OL-21851-01