Default Physical Ethernet Settings - Cisco Nexus 3000 series Configuration Manual

Default Physical Ethernet Settings

Trunk encap. type:
Channel:
Broadcast suppression: percentage(0-100)
Flowcontrol:
Rate mode:
QOS scheduling:
CoS rewrite:
ToS rewrite:
SPAN:
UDLD:
MDIX:
FEX Fabric:
The following example shows how to display the physical Ethernet transceiver:
switch# show interface ethernet 1/1 transceiver
Ethernet1/1
The following example shows how to display a brief interface status (some of the output has been removed
for brevity):
switch# show interface brief
--------------------------------------------------------------------------------
Ethernet
Interface
--------------------------------------------------------------------------------
Eth1/1
Eth1/2
Eth1/3
Eth1/4
Eth1/5
Eth1/6
Eth1/7
...
The following example shows how to display the CDP neighbors:
switch# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
Device ID
d13-dist-1
n5k(FLC12080012)
Default Physical Ethernet Settings
The following table lists the default settings for all physical Ethernet interfaces:
Parameter
Duplex
Encapsulation
Cisco Nexus 3000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)U1(1)
20
802.1Q
yes
rx-(off/on),tx-(off/on)
none
rx-(6q1t),tx-(1p6q0t)
no
no
yes
yes
no
yes
sfp is present
name is CISCO-EXCELIGHT
part number is SPP5101SR-C1
revision is A
serial number is ECL120901AV
nominal bitrate is 10300 MBits/sec
Link length supported for 50/125mm fiber is 82 m(s)
Link length supported for 62.5/125mm fiber is 26 m(s)
cisco id is --
cisco extended id number is 4
VLAN Type Mode
200 eth trunk
1 eth trunk
300 eth access down
300 eth access down
300 eth access down
20 eth access down
300 eth access down
S - Switch, H - Host, I - IGMP, r - Repeater,
V - VoIP-Phone, D - Remotely-Managed-Device,
s - Supports-STP-Dispute
Local Intrfce
mgmt0
Eth1/5
Status Reason
up none
up none
SFP not inserted
SFP not inserted
Link not connected
Link not connected
SFP not inserted
Hldtme Capability
148 S I
8 S I s
Default Setting
Auto (full-duplex)
ARPA
Configuring Ethernet Interfaces
Speed Port
Ch #
10G(D) --
10G(D) --
10G(D) --
10G(D) --
1000(D) --
10G(D) --
10G(D) --
Platform Port ID
WS-C2960-24TC Fas0/9
N5K-C5020P-BA Eth1/5