Default Physical Ethernet Settings - Cisco nexus 5000 series Cli Configuration Manual

Chapter 1 Configuring Ethernet Interfaces
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Port
--------------------------------------------------------------------------------
...
Eth1/1
Eth1/2
Eth1/3
...
The following example shows how to display the CDP neighbors:
switch# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
Device ID
d5-switch-9.qa.
dist-row-d

Default Physical Ethernet Settings

The following table lists the default settings for all physical Ethernet interfaces:
Parameter
Debounce
Duplex
Encapsulation
MTU
Port Mode
Speed
1. MTU cannot be changed per-physical Ethernet interface. You modify MTU by selecting maps of QoS classes. See
OL-16597-01
Debounce time
enable
enable
enable
S - Switch, H - Host, I - IGMP, r - Repeater,
V - VoIP-Phone, D - Remotely-Managed-Device,
s - Supports-STP-Dispute
Local Intrfce
Eth1/40
mgmt0
1
"Configuring QoS," for additional information.
Value(ms)
100
100
100
Hldtme Capability
148 R S I
147 R S I
Default Setting
Enable, 100 milliseconds
Auto (full-duplex)
ARPA
1500 bytes
Access
Auto (10000)
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Displaying Interface Information
Platform Port ID
WS-C6506-E Ten4/2
WS-C3560G-48T Gig0/34
Chapter 1,
1-11