Supportftp - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

Brocade fabric os command reference guide v6.1.0 (53-1000599-02, june 2008)
Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:
Table of Contents

Advertisement

supportFtp

Sets, clears, or displays support FTP parameters, or a time interval to check the FTP server.
Synopsis
supportftp [-S]
supportftp -s [-h hostip][-u username][-p password][-d remotedirectory]
supportftp -t hours
supportftp -R
supportftp -e
Description
Use this command to set, clear, or display support FTP parameters, or a time interval to check the
FTP server. This command displays IPv4 and IPv6 addresses.
Note
The execution of this command is subject to Admin Domain restrictions that may be in place.Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands
This command has the following mutually exclusive operands:
-S
-s
-t hours
-R
-e
If no parameter is not specified, the supportFtp command defaults to supportFtp -S.
Examples
To set the FTP parameters:
To display the FTP parameters:
Fabric OS Command Reference
53-1000599-02
Displays the FTP parameters.
Sets the FTP parameters. -s has the following optional operands:
-h hostip
Specifies the FTP host IP address. It must be an IP address. hostip should be
less than 48 characters.
-u username
Specifies the FTP user name. username should be less than 48 characters.
-p password
Specifies the FTP user password. If the user name is anonymous, the
password is not needed. password should be less than 48 characters.
-d remotedirectory
Specifies the remote directory for storing trace dump files. supportFtp cannot
take a slash (/) as a directory name. remotedirectory should be less than 48
characters.
Sets the time interval for checking the FTP server. The -t operand has the
following required operand:
hours checks the connectivity of FTP server at the indicated time interval (in
hours).
Removes all files from the switch; //clears parameters
Enables auto file transfer.
switch:admin> supportftp -s -h 1080::8:800:200C:417A -u njoe -p password -d support
supportftp: ftp parameters changed.
switch:admin> supportftp
2
supportFtp
623

Advertisement

Table of Contents
loading

Table of Contents