Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 121

Brocade fabric os command reference guide v6.1.0 (53-1000599-02, june 2008)

Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:

Table of Contents

Enable CLOSE on OPEN received?

Always send RSCN? Following the completion of loop initialization, a remote state change

System Services Settings

Settings affecting System Services are described

Disable RLS probing

Disable RLS probing Enables or disables the read link status (RLS) probing. Performed by the FCP

Portlog Events Enable/Disable Settings

These settings determine whether or not various types of port events are logged.

Each event type displayed on the screen is enabled by default ("on"). When disabled, this event is

not logged by the port log.

Application Attributes

Fabric OS Command Reference

53-1000599-02

If this is set, a CLS is returned immediately to an OPN if no buffers are

available. This is required for TachLite.

notification (RSCN) is issued when FL_Ports detect the presence of new

devices or the absence of pre-existing devices. When set to 1, an RSCN is

issued upon completion of loop initialization, regardless of the presence or

absence of new or pre-existing devices.

Disable RLS probing

daemon, RLS probing reads the link error block from the device. This

extended link services command is defined by the FC standards. Refer to the

FC standards for information. This parameter is enabled ("on") by default;

"off" disables RLS probing.

lists configurable application attributes. By default, all application attributes are enabled.

Configurable application attributes

Certificate File

CA Certificate File

Length of crypto key

Secure RPCd Callback secret

Enforce secure Config Upload/Download

Enforce signature validation for firmware

Basic User Enabled

Perform License Checking and Warning

Allow Fabric Event Collection