Urouteshow - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

uRouteShow

uRouteShow
Displays unicast routing information.
Synopsis urouteshow [slotnumber/][portnumber] [domain]
Description Use this command to display the unicast routing information for a port, as it is known by the FSPF
path selection and routing task. The routing information describes how a frame that is received
from a port on the local switch is to be routed to reach a destination switch.
The following information displays:
Local Domain ID
In Port
Domain
Out Port
Metric
Hops
Flags
Next (Dom, Port)
The information provided by this command should match what is provided by portRouteShow and
topologyShow.
Operands This command has the following operands:
slotnumber
portnumber
domain
686
Domain number of local switch.
Port from which a frame is received. Except for the cases in which you
perform a port swap or enable extended-edge PID (PID Format 2) on a switch,
the value is equal to the Area field displayed by the switchShow command.
Refer to Fabric OS Administrator's Guide for more information regarding the
extended-edge PID format.
Destination domain of incoming frame.
Port to which the incoming frame is to be forwarded. Except for the cases in
which you perform a port swap or enable extended-edge PID (PID Format 2)
on a switch, the value is equal to the Area field displayed by the switchShow
command. For port swap operations, the value is equal to the Swport field
displayed by the portSwapShow command. Refer to Fabric OS Administrator's
Guide for more information regarding the extended-edge PID format.
Cost of reaching the destination domain.
Maximum number of hops required to reach the destination domain. If the
number of hops are different for some multiple equal cost paths (to reach the
same domain), then it displays the maximum number.
Indicates rout type as either dynamic (D) or static (S). A dynamic route is
discovered automatically by the FSPF path selection protocol. A static route is
assigned using the command uRouteConfig.
Domain and port number of the next hop. These are the domain number and
the port number of the switch to which Out Port is connected.
For bladed systems only, specify the slot number of the input port whose
routes are displayed, followed by a slash (/).
Specify the number of the input port whose routes are to be displayed,
relative to its slot for bladed systems. Use switchShow to display a list of valid
ports. This operand is optional; if omitted, the command displays routing
information for all input ports in the switch.
Specify a remote domain in the fabric for which routing information is to be
displayed. This operand is optional; if omitted, the routing information for all
domains in the fabric is displayed.
Fabric OS Command Reference
53-1000599-02