Cfgcreate - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

cfgCreate

cfgCreate
Creates a zone configuration.
Synopsis cfgcreate "cfgName", "member[ ;member...]"
Description Use this command to create a new zone configuration.
This command changes the Defined Configuration (see cfgShow). For the change to become
effective, enable the configuration with the cfgEnable command. For the change to be preserved
across switch reboots, save the configuration to nonvolatile memory with the cfgSave command.
Notes When FCS policy is enabled, this command can be issued only from the primary FCS switch.
Refer to the zoneCreate command for more information on name and member specifications.
Operands The following operands are required:
"cfgName"
"member"
Examples To create a configuration containing three zones:
See Also cfgAdd, cfgClear, cfgDelete, cfgDisable, cfgEnable, cfgRemove, cfgSave, cfgShow
58
Specify a name for the zone configuration in quotation marks. A zone
configuration name must begin with a letter followed by any number of
letters, numbers, and underscores. Names are case-sensitive. For example,
"Cfg_1" and "cfg_1" are different zone configurations. Blank spaces are
ignored.
Specify a zone member or list of zone members to be added to the
configuration. The list must be enclosed in quotation marks. Members must
be separated by a semicolons. The zone configuration member list must have
at least one member. Empty member lists are not allowed.
switch:admin> cfgcreate "USA_cfg", "Red_zone;Blue_zone;Green_zone"
Fabric OS Command Reference
53-1000599-02