Configure - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

configure

configure
Changes system configuration settings.
Synopsis configure
Description Use this command to change the following system configuration settings for the switch:
•
•
•
•
•
•
•
•
•
•
•
•
•
Notes To access all parameters controlled by this command, you must disable the switch using the
switchDisable command. If executed on an enabled switch, only a subset of attribute can be
configured.
The Telnet interface is no longer configurable with this command. Use the ipFilter command to
enable or disable the Telnet interface.
The SNMP attributes are no longer configurable with this command. Use snmpConfig --set
seclevel to configure SNMP attributes.
The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands none
The configure command runs in interactive mode and presents you with a series of hierarchical
menus. Each top-level menu and its associated submenus consist of a text prompt, a selection of
valid values, and a default value (in brackets).
The following keys control the execution of the command:
Return
Interrupt (Ctrl-C)
End-of-file (Ctrl-D)
The following parameters can be modified with the configure command:
90
Switch fabric settings
Virtual channel parameters
F_Port login parameters
Zoning operation parameters
Remote State Change Notifications (RSCN) transmission mode
Arbitrated Loop Parameters
System Services Settings
Portlog Events enable or disable Settings
Secure Socket Layer (SSL) attributes
Remote Procedure Call Daemon (RPCD) attributes
cfgload attributes
Webtools attributes
System settings
When entered at a prompt with no preceding input, the command accepts the
default value (if applicable) and moves to the next prompt.
Aborts the command immediately and ignores all changes made.
When entered at a prompt with no preceding input, terminates the command
and saves changes made.
Fabric OS Command Reference
53-1000599-02