Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 199

Notes The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
This command is supported only on Brocade FR4-18i blades and Brocade 7500 platforms.
Operands This command has the following operands:
--slot slotnumber
-unit number
-path mode
-nframes count
Examples To test slot 2 with FC Router FPGA Serdes loopback sending 10 frames:
Diagnostics When a failure is detected, the test might report one or more of the following:
See Also fcrChipTest, miniCycle, portLoopbackTest
Fabric OS Command Reference
53-1000599-02
RANDOM0x25, 0x7f, 0x6e, 0x9a, ...
Specifies the slot number on which the diagnostic operates. The default is 0
and operates on fixed-port-count products.
Specifies the FC Router FPGA to test. By default, all FC Router FPGAs in the
specified slotnumber are used. Valid number values include:
0 FC Router FPGA 0
1 FC Router FPGA 1
2 All FC Router FPGAs
Specifies the loopback point for the test. By default, fcrPathTest uses central
ASIC loopback. Valid mode values include:
1 Central ASIC loopback
2 FC Router FPGA Serdes loopback
3 FC Router FPGA internal loopback
Specifies the number of frames to send. The test progresses until the
specified number of frames are transmitted on each port. The default value is
10.
switch:admin> fcrpathtest
Running fcrpathtest ..............
Test Complete: fcrpathtest Pass 10 of 10
Duration 0 hr, 0 min & 18 sec (0:0:18:942).
passed.
-
DATA
-
ERRSTAT
-
INIT
-
PORTDIED
-
STATS
-
TIMEOUT
-
XMIT
slot 2 -path 2 -nframes 10
--
2
fcrPathTest
173