Setdbg - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

setDbg

Sets the debug level of the specified module.
Synopsis setdbg [module_name][level]
Description Use this command to set the debug level of a specified module. Debug levels filter the display of
debug messages to the serial console. By default, no debug messages are displayed.
High debug level values can generate a large volume of messages, degrading the system response
time.
The set of supported modules and their current debug levels are displayed by the command
dbgShow.
Note The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
module_name
level
Examples To set the debug level for a module named NS to value 3:
See Also dbgShow
Fabric OS Command Reference
53-1000599-02
Specify the name of the module for which you want to view the debug and
verbosity levels. Module names are case-sensitive. This operand is optional; if
omitted, this command displays the debug and verbose level for all modules.
Specify the debug level for the specified module (0 to 9). A zero (0) value
(default) specifies that no messages are to display. Higher values cause more
messages from that module to display. This operand is optional; if omitted,
this command displays the current debug and verbose level of the specified
module.
switch:admin> setdbg NS 3
switch:admin> dbgshow NS
Module NS, debug level = 3, verbose level = 0
2
setDbg
591