Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 541

portPhys
portScn
port generation number
portId
portIfId
portWwn
portWwn of devices(s) connected
Distance
portSpeed
LE domain
FC Fastwrite
If the port is configured as an EX_Port, the following additional port information is displayed:
EX_Port Mode
Fabric ID
Front Phantom
Pr Switch Info
Fabric OS Command Reference
53-1000599-02
Testing Running diagnostics.
Faulty Failed diagnostics.
Persistently Disabled
Persistently disabled.
The port's physical state:
No_Card No interface card present.
No_Module No module (GBIC or other) present.
No_Light Module is not receiving light.
No_Sync Receiving light but out of sync.
In_Sync Receiving light and in sync.
Laser_Flt Module is signaling a laser fault.
Port_Flt Port marked faulty.
Diag_Flt Port failed diagnostics.
Lock_Ref Locking to the reference signal.
The port's last State Change Notification.
The port's generation number for the last offline state change.
The port's 24-bit port ID.
The user port's interface ID.
The port's World Wide Name.
The World Wide Port Names of connected devices.
The port's long-distance level. In case of LD mode, the user configured
distance and actual distance also are displayed. See portCfgLongDistance for
information on long distance levels.
The port's fixed speed (1, 2, 4, or 8 Gbps) or negotiated speed (N1 Gbps, N2
Gbps, N4Gbps, N8 Gbps or AN).
The LE domain ID.
The status of FC Fastwrite (ON or OFF).
The port is configured as an EX_Port.
The fabric ID assigned to this EX_Port; therefore, it is the fabric ID of the edge
fabric attached to this EX_Port.
Information on the front phantom domain presented by this EX_Port. Includes
the preferred (if not active) or actual (if active) domain ID for the front domain
and the WWN of the front domain.
Information on the principal switch of the edge fabric attached to this
EX_Port. Includes the domain ID and WWN of the principal switch.
2
portShow
515