Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 53

AG failover policy commands
1. To display failover policy settings for all N_Ports:
2. To set and display failover and failback policies on a single port:
3. To display failback policy settings for all the N_Ports:
4. To set and display failback policy settings on a single port:
Fabric OS Command Reference
53-1000599-02
switch:admin> ag --prefdel 5 2
Preferred N_Port is deleted successfully for the F_Port[s]
switch:admin> ag --mapdel 2 "5"
F_Port to N_Port mapping has been updated successfully
NOTE: Preferred Port commands are discussed in detail below.
switch:admin> ag --failovershow
N_Port failover_bit
---------------------------
0
1
2
3
switch:admin> ag --failoverenable 1
Failover policy is enabled for port 1
switch:admin> ag --failoverdisable 0
Failover policy is disabled for port 0
switch:admin> ag --failovershow 0
Failover on N_Port 0 is not supported
switch:admin> ag --failbackdisable 2
Failback policy is disabled for port 2
admin> ag --failbackshow 2
Failback on N_Port 2 is not supported
switch:admin> ag --failbackenable 2
Failback policy is enabled for port 2
switch:admin> ag --failbackshow
N_Port failback_bit
---------------------------
0 0
1 1
2 0
3 1
switch:admin> ag --failbackenable 0
Failback policy cannot be enabled since failover
policy is disabled for port 0
switch:admin> ag --failbackenable 2
Failback policy is enabled for port 2
switch:admin> ag --failbackenable 3
Failback on N_Port 3 is not supported
1
0
1
0
2
ag
27