Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 473

-i mode
Examples To set the fabric ID of port 2/1 to 5 and the port ID format to core:
To configure port 2/0 to be an EX_Port and set the fabric ID to 4:
To disable fabric parameter negotiation on port 2/0 of an EX_Port:
To enable IDID on port 2:
To display the configuration on port 2:
See Also portCfgVEXPort, portDisable, portEnable, portShow, portCfgDefault, fcrbCastConfig
Fabric OS Command Reference
53-1000599-02
Enables or disables Insistent Domain Id (IDID) for the specified EX_Port.
Specify 1 to enable IDID, specify 2 to disable IDID. This command must be
issued from a McDATA edge switch attached to a single or dual FCR
configuration.
switch:admin> portcfgexport 2/1 -f 5 -p 1
switch:admin> portcfgexport 2/0 -a 1 -f 4
switch:admin> portcfgexport 2/0 -t 2
switch:admin>portcfgexport 2 –i 1
switch:admin> portcfgexport 2
Port 2 info
Admin:
State:
Pid format:
Operate mode:
Edge Fabric ID:
Preferred Domain ID:
Insistent Domain ID Mode:
Front WWN:
Fabric Parameters:
R_A_TOV:
E_D_TOV:
Authentication Type: None
DH Group: N/A
Hash Algorithm: N/A
Edge fabric's primary wwn: N/A
Edge fabric's version stamp: N/A
enabled
NOT OK
Not Applicable
Open
70
109
enabled
50:00:51:e3:76:0e:4e:46
Auto Negotiate
Not Applicable
Not Applicable
2
portCfgEXPort
447