Portcfgnpivport - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

portCfgNPIVPort

portCfgNPIVPort
Enables or disables N_Port ID virtualization (NPIV) functionality on a port.
Synopsis [slot/]port,mode
Description Use this command to enable or disable NPIV functionality on a port. NPIV is only applicable to
F_Ports.
The following conditions must be met for a switch port to respond to NPIV requests from an NPIV
device:
NPIV capable:
NPIV enabled:
NPIV HA:
Up to a maximum of 255 virtual port IDs are allocated per NPIV port. The maximum number of
virtual IDs can be configured from 0 to 255 per port. The default value is 126 per port. The number
of virtual port IDs per switch can be configured with the configure command.
Note Changes made by this command are persistent across switch reboots and power cycles.
Use the portCfgShow command to determine whether NPIV is enabled on a port. Use the
portCfgDefault command to reset all port configurations, including the NPIV configuration of a port.
The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
slot
port
mode
Examples To enable NPIV functionality on a port:
456
NPIV capability is a switch blade or port attribute that is required for NPIV
functionality to operate. Some blades within a switch, or some ports within a
switch or blade, might not have NPIV capability. NPIV functionality cannot be
enabled on such ports and they do not respond to NPIV requests.
NPIV functionality must be enabled on a port for it to respond to NPIV
requests. By default, NPIV is enabled on all Condor and Golden-eye-based
ports. It can be selectively enabled or disabled on switch ports using this
command.
For a redundant control processor (CP) system to enable NPIV functionality, it
must be running NPIV-enabled firmware versions on both the active and
standby CPs. This requirement does not apply to single CP systems.
For bladed systems only, specify the slot number of the port to be configured,
followed by a slash (/).
Specify a port number to be configured, relative to its slot for bladed systems.
Use switchShow to display a list of valid ports.
Specify 1 to enable and 0 to disable the NPIV function.
switch:admin> portcfgnpivport 1/3 1
Fabric OS Command Reference
53-1000599-02