Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 687

To perform a system shutdown of the FR4-18i AP blade from the active CP:
To attempt a system shutdown from the standby CP (not supported):
See Also haDisable
Fabric OS Command Reference
53-1000599-02
flushing ide devices: hda
Power down.
ppc440gx System Halted
switch:admin> sysshutdown
This command will shutdown the operating systems on your switch.
You are required to power-cycle the switch in order to restore operation.
Are you sure you want to shutdown the switch [y/n]? y
This is the active Cp
2005/11/16-05:47:20, [FSSM-1003], 5641,, WARNING, Brocade12000, HA State out
of sync
HA is disabled
Stopping blade 2
Shutting down the blade....
Stopping blade 8
Shutting down the blade....
Broadcast message from root (ttyS0) Wed Nov 16 05:47:20 2005...
The system is going down for system halt NOW !!
INIT: Switching to runlevel: 0
INIT: Sending processes the TERM signal
Unmounting all filesystems.
umount2: Device or resource busy
umount: /tmp: device is busy
The system is halted
flushing ide devices: hda
Power down.
ppc440gx System Halted
switch:admin> sysshutdown
Shut down the whole system is not support from the standby CP
For shut down the whole system
please run the sysshutdown from the active CP
2
sysShutDown
661